Select XLS
Pairing SMART-R to an XLS controller
The heater is equipped with our built-in SMART-R XLS receiver (located on the rear of the panel).
There is a power ON/OFF switch on the receiver and there are indicators to show if the panel is paired to a controller
and if the heating is ON or OFF.
The heater needs to be paired to a Herschel XLS controller (supplied separately). Once paired it will receive ON/OFF
commands from the controller.
IMPORTANT: The panel itself does not have an in-built temperature sensor. Efficient use of the heater is only possible
by pairing it with an XLS controller. The SMART-R XLS receiver will not pair with a non-Herschel XLS controller. SMART-R
WILL NOT pair with a Herschel iQ series control (T1 or Hub).
The Herschel XLS controllers can be paired with and control one or many heater panels. The temperature of the room
will be measured by the XLS controller. It is normal to use one controller per room but if it is a large room (such as open
plan area) you may want to consider more than one thermostat controller. If there are multiple heating panels per
room, pair each panel to the relevant room controller.
Operation
–
using with XLS controls
All Herschel Select XLS panels are equipped with a SMART-R XLS receiver on the rear of the rear panel. SMART-R will
pair wirelessly (via RF) with XLS thermostatic controllers. The
T-BT
is a battery operated thermostat. Wi-Fi and APP
control is not possible with
T-BT.
For WiFI and APP control the
T-PL
is a simple to use thermostat control which plugs into a mains socket. These are
perfect for retrofits and portable heating solutions.
For new build and renovations chose the hard wired
T-MT
mains powered thermostat which is WiFi enabled.
All control options can be paired with the SMART-R. The controller then sends commands to turn the heater on or off
according to the room temperature and program.
SMART-R
T-BT
T-MT
T-PL
(no WiFi)
