Customer manual
LFM 4x Reader
RFID
WE GENERATE SOLUTIONS
HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: +49 9279 991 - 0
LFM 4x Reader Rev1.3
back to the table of contents
85
Software version
Where used
S1F2
Result information about the status of the request for the service request.
„NO“
Normal Operation
Indicates the success of the requested operation.
„EE“
Execution error
Transponder data cannot be read. MID sequence cannot be read, as valid ASCII characters were not
found exclusively in the defined MID area. However, the condition of the facilities is normal.
„CE“
Communication error
Syntax error in message, message format, or value.
„HE“
Hardware error
Error in the head of the ID reader / writer, head of the ID reader / writer is deactivated.
„TE“
Transponder error, reading / writing unsuccessful (Tag Error)
„NT“
No transponder detected in the antenna area. (No Tag)
Where used
S18F2, S18F4, S18F8, S18F10, S18F12, S18F14
Specifies an operation to be performed by the subsystem. Used to distinguish between the various
subsystem commands displayed.
„ChangeState“
… change status
„GetStatus“
… query staus
„Reset“
… reset CIDRW
„PerformDiagnostics“
… A diagnosis is made.
„ADJUST“
… triggers an automatic alignment of the antenna.
„HERMOSDefParams“ … Basic setting of the readers parameters.
„SetLED „
… Set one of the device LEDs.
CPVAL‘s
1 <LEDStatus>
2 <Timeout>
3 <LEDNo>
Where used
S18F13
SSCMD
Format: A[max 18]
SOFTREV
Format: A[max 6]
SSACK
Format: A[2]
