Nook Table
Assembly Instructions
1BSSGT
rev
B
3
5.2 Install the return panel (Left Side) to the work surface using the
pan head screws.
Step 6:
6.1 Secure the return panel to the main panel using barrel screws
and M8 Machine screw and nut.
Step 7:
7.1 Install the plastic clips through the slots at the top and bottom
of the screen joint.
7.2 Install the trim piece from the top and push it down over the
plastic clips.
8.2
8.1
Step 8:
8.1 Peel the backer o of the dampener and stick it to the return
panel. Use the end bracket to roughly align the dampener as shown
below. Repeat for other panel.
8.2 Liners are magnetic on the back. Align the liner so that the top
edge of the liner is sub-flush to the metal screen by approximately 2mm.
Note: Locate the slits in the side liner so that they roughly align with
the ends of the screen bracket. (8.2)
7.1
7.2
M8 Machine screw and nut.
Barrel screw
