Nook Table
Assembly Instructions
1BSSGT
rev
B
2
Step 3:
3.1 To attach legs to the worksurface follow the below procedure.
A. Screw two flat head screws into marked two piloted holes first to
locate the leg.
B. Finish by installing additional flat head screws in marked
locations that are NOT piloted. These screws are field drilled.
c. Repeat step 3 for remaining legs.
NOTE: Attach legs with worksurface upside down.
Step 4
4.1 Install the metal screen (Main panel) to the work surface.
A. Locate main panel with the two pilot holes
B. Fasten the remaining screws
Step 5
5.1 Install the return panel (Right Side) to the work surface using the
pan head screws.
A. Locate return panels with the two pilot holes
B. Fasten the remaining screws
NOTE:
The Side liners and dampeners should be installed prior to
attaching the return panel to the work surface. (See Step 8)
A.
Two piloted holes location
B. Field Drill location
Do not tighten the screw. Screen mount needs to
be position here first and then attach that with
pan head screw.
A
A
