Assembly Instructions
7
HermanMiller for Motia
TM
Table
1BGGNR rev K
Step 18
Switch Installation
Note: If table is using the LO100 smart paddle kit, see instruction sheet
1BHGK1 for switch installation details.
18.1 Install the Switch using 2 Tapping Screws in the predrilled
corner holes in the worksurface.
Note: Switch can be installed either right or left side of table.
Switch will be on opposite side from control box.
Cables will be fastened to surface in step 10.
Step 19
19.1 Plug the switch cable to Control Box.
Step 20
20.1 Plug the Power Cord to Control Box.
Step 17
17.1 Verify that Standard (single stage) “SS” or “HS” or Extended (dual
stage) “DS” Symbol on control box label matches the symbol on the Leg
Column’s Cord Label.
6.2 Plug the cables to Control Box.
Control Box Label
Leg Column Cord Label
WARNING
Use only components with matching labels. Using table with mismatched controller and legs
can result in leg stage separation causing table to fall resulting in possible personal injury.
ATTENTION
N’utilisez que les composants dont les étiquettes correspondent. Une table dont les pieds et
le mécanisme de commande ne correspondent pas risque de se séparer au niveau du
piètement, de tomber et de blesser l’utilisateur.
