Assembly Instructions
5
HermanMiller for Motia
TM
Table
1BGGNR rev K
Step 10
10.1 Fasten the Cable Holders to the work surface with the switch and
leg cables in the Cable Holders.
Step 11
11.1 Turn Table upright and plug in power cord to receptacle.
11.2 Cycle worksurface all the way up and down to verify legs are
synchronized.
Note: If legs are not synchronized, synchronize them by running the legs all
the way down and holding for 5 seconds and then repeat Step 11.
Step 12
Corner Table
Top and Corner Mounting Plate Installation
12.1 Identify on the surface which side the control box will be mounted
and face the cable in this direction.
12.2 Ensure the cable is routed in the cutout.
12.3 Install the Stamping Plate to the leg using 4 socket screws.
12.4 When torque wrench is available, tighten fasteners to 20 Ft-Lbs. If you
do not have access to a torque wrench, then tighten fasteners to snug,
plus a ¼ turn.
12.5 Do the same for other legs.
Top Mounting Plate
Corner Mounting Plate
Step 9
9.1 Plug the Power Cord to Control Box.
