Assembly Instructions
3
HermanMiller for Motia
TM
Table
1BGGNR rev K
Step 2
Step 3
Leg Installation
2.1 Lay the Surface upside down.
2.2 Using the 2 predrilled holes to locate, install the leg
using 14 tapping screws.
2.3 Do the same for other leg.
T Foot or C Foot Installation
3.1 Install the T Foot or C Foot to the leg using 2 cap screws.
3.2 When torque wrench is available, tighten fasteners to 20 Ft-Lbs. If you
do not have access to a torque wrench, then tighten fasteners to snug, plus
a ¼ turn.
3.3 Do the same for other leg.
Step 4
Stiffener Installation
4.1 Find the predrilled holes located near legs.
4.2 Attach the Stiffener to the rear side of worksurface using
Tapping Screws.
Note: If worksurface other than Herman Miller’s is being installed.
Center legs front to back.
Distance between legs to be determined by length of stiffener.
Step 1
Top Mounting Plate Installation
1.1 Pick the side on the leg where the power cable runs, face the cable
towards the center of the table.
1.2 Ensure the cable is routed in the cutout.
1.3 Install the Stamping Plate to the leg using 4 socket screws.
1.4 When torque wrench is available, tighten fasteners to 20 Ft-Lbs. If you
do not have access to a torque wrench, then tighten fasteners to snug,
plus a ¼ turn.
1.5 Do the same for other leg.
