Assembly
Connecting fluid and air hoses
STEP 7
Connect the black 5/32" air hose between the regulator
and the air in port of the limit valve located on the rear leg
of the gun washer. Press tubing in through the collar until
seated. Pull firmly on hose to test for a tight connection.
(see
fig.4).
Note: Air in port of limit valve is the port opposite the roller.
STEP 8
Connect the blue 5/32" air hose between the air in port of
limit valve located on the front leg and the air out port of the
limit valve located on the rear leg of the gun washer.
Press tubing in through the collar until seated. Pull firmly on
hose to test for a tight connection (see fig.4).
STEP 9
Connect the clear 5/32" air hose between the pump and
the air out port of the limit valve located on the front leg
of the gun washer. Press tubing in through the collar until
seated. Pull firmly on hose to test for a tight connection, then
place the tub in the stand, bulkheads near the pump (see fig.4).
STEP 10
Connect the solvent tubes from the solvent transfer panel
to the gun washer as shown in fig. 6.
STEP 11
Attach the panel to the stand using (2) 10-24 x 3/4 screws
(2) 10-24 lock nuts, (2) 1/4" lock washers and (2) 1/4" acorn
nuts (see fig.5).
Note: 1/4" acorn nuts and 1/4" lock washers were installed
in step 1.
STEP 12
Insert the hose hanger into 1/4" slot in the panel (see fig. 5).
Limit valve
Limit
valve
Clear air
hose
Upper bulkhead
Lower
bulkhead
fig.4
Black air
hose
Blue air
hose
Connect to upper
pump fitting
Connect to lower
pump fitting
Connect to upper tub
bulkhead
Connect to lower tub
bulkhead
Solvent fill hose
Connect to recycler
outlet (or new
solvent container)
Solvent drain hose
Connect to recycler
inlet (or old solvent
container)
fig.5
1/4" Acorn nut
1/4" Lock
Washer
10-24 X 3/4
Screw
Hose hanger
fig.6
Page 6 of 20
