7
General information on safety and
accident prevention
The safe and accident-free operation of this tool is
assured only if you read this safety information and
the operating instructions carefully and observe the
same.
Every time you use the machine, always check
the mains cable and plug first. Only work with the
machine when it is in perfect working order and
undamaged. Have any damaged parts repaired
or replaced immediately by a qualified
electrician.
Always unplug the machine before doing any
work on it, before changing tools and when the
machine is not in use.
To prevent damage to the mains cable, always
lead it away from the rear of the machine.
When working outdoors, use only approved
extension cables. The extension cable used
must have a cross-section of at least 1.5 mm
2
.
The plug connections must be earthed and
splash-proof.
Always keep your tools in a safe place and away
from children.
Clamp the workpiece in place to prevent slipping.
Do not plane materials which
contain asbestos.
Observe the professional association’s accident-
prevention regulations (VBG 119) on this point.
Use only original spare parts.
Have any repair work which may be necessary
performed only by a qualified electrician.
Noise levels at the place of work may exceed 85
dB (A). If this is the case, operating personnel
must be equipped with ear defenders. The noise
emitted by this electric tool was measured to IEC
59 CO 11, IEC 704, DIN 45635 Part 21, NFS 31-
031 (84/537/EEC).
Make sure you have a firm footing when working
with the machine. Avoid abnormal postures.
Do not expose your electric tool to the rain. Do
not use electric tools in wet or damp
surroundings or near flammable liquids.
Do not carry the electric tool by the mains cable.
Protect the mains cable from damage by oil,
solvents and sharp edges. Do not carry the
electric tool by the cable.
Keep your workplace clean and tidy.
Make sure the ON/OFF switch is in the OFF
position before you plug in the machine.
Wear suitable work clothes. Do not wear loose-
fitting clothes or jewelry. If you have long hair,
wear a hair net.
For your own safety, use only original
accessories and spare parts made by the
machine manufacturer.
The machine vibrations were analyzed according
to ISO 5349.
GB
Anleitung 12 Spr. 24.10.2001 15:39 Uhr Seite 7
