Herkules Hebetechnik GmbH K1200-HLS-61, Operating Manual And Test Record

Page: 27 / 46

O
PERATION
27
9.4 Loading ramps
When the elevated lifting platform serves the loading ramps as a roll-off protection. You may not be away,
during the use of the lifting platform. It is important to check before starting work, whether the loading ramps
are set up properly.
Picture 6: Elevated lifting platform with mounted loading ramp
9.5 Function interim drive over ramp (HLS1200-61)
The interim drive over ramps may be folded down if needed, for even better access to the raised vehicle.
Before lowering the lifting platform in the basic setting the interim drive over ramps must be raised (see
picture
interim drive over ramp in normal position ).
Picture 7 / 8: Interim drive over ramp in the basic position / interim drive over ramp is folded down.
9.6 Function protective flaps (HLS1200-64)
The protective flaps on the cantilever of the lifting platform satisfy an important safety feature. You prevent
the retraction of lifting platform in the pit / grid russeting of accidental clamping / crimping of such. B. Body
parts.
9.7 Function CE-Stop (HLS1200-66)
The CE-stop replaces the protective flaps. Ca. 120mm before the end of lowering the lifting platform stops
automatically. Only by acknowledging the control valve (back to 0-position and re-lowering AB), the lifting
platform runs to the accompaniment of an acoustic signal completely into the pit / grid russeting.