hergom SERE 100, Installation, Use And Maintenance Instructions, Page: 20 / 52

20
1.3 – OPTIONAL OUTLET CONNECTION Ø70 mm
(NOT INCLUDED)
2 - REMOVING THE FAN
ATTENTION! Before working on electrical parts be
sure the appliance has been disconnected from the
mains.
In order to replace the fans, observe the following
instructions:
1. Remove the deflector units, the sides and the
bottom section. Pay attention to vermiculite
parts; they can break. (Fig. 3)
2.
Loosen the 2 top screws that secure the fan
assembly and remove it from its housing by
pulling gently upwards. (Fig. 4 and Fig. 5).
3. Disconnect the two terminals. Then loosen the
two bottom screws holding the fan in place. (Fig.
6).
FIG. 4
FIG. 5
FIG. 6
4.
Replace the damaged fan and install the fan
assembly by performing the above steps in
reverse order.
Ref. 9920618
FIG. 2
FIG. 3