Pag.8
3.1 Connection the gas lines
You can determine where the gas pipes will be placed, depending on the positioning of the appliance.
Ensure control equipment is not twisted during installation and there is no excessive tension.
Accessibility of various connection points in relation to components need to be maintained.
After installation, check the connections for gas leakage. Use a 3/8“ gas tap in the main gas supply.
Ensure the gas pipes are dirt-and sand-free.
The gas connection should only be done without
any excessive tension in the tubes etc. This prevents any damage occurring to the gas control equipment.
3.2 Preparation and installation
*
Open the door.
*
Remove the packaging and check the unit for possible damage.
*
Please note: place the unit on a stable surface.
*
Do not place the unit on its back/side!
*
Place the unit at the installation location
*
Take all the packaged components out of the unit and check to make sure they are not
damaged or broken.
*
Situate the unit (see Appendix 2 as an example of an installation location) in your chosen
installation location.
*
The adjustable feet allow to adjust the device more refined.
3.3 Fitting the ceramic log inset (see Appendix 3)
Method:
*
Spread the glowing material (lava granules) evenly over the burner and the burner decoration plate
so that they are just covered. Glowing embers can be placed here and there as decoration.
*
Place the ceramic wood blocks in the correct order as shown on Appendix 3.
*
Place the logs carefully. Other location can seriously affect the flames or malfunction of the
burn process (sooting)
*
Slot/opening between burner and mesh deco plate must be kept free of glowing material.
*
Before closing the door make sure if there must be a restriction plate to be placed or not.
See chapter 7
"Concentric chimney lay out"
*
If there is a restriction required for your situation, remove the baffle plate by unscrewing it
from the front of the plate and move the plate backwards and then out. Now install the restriction
plate with two screws and replace the baffle plate.
*
Close the door.
NOTICE
Before installing the device it is recommended to first read Chapter 7
"Concentric flue system"
to consult.
3. PLACING THE APPLIANCE
Notice
MAKE SURE THE PILOT LIGHT REMAINS UNOBSTRUCTED!
Note:
when installing the log set and the various glowing materials and accessories, the following must
be taken into account:
A:
No glowing material in or on the pilot burner.
B:
Prevent that ceramic material falls on the glass seals. Remove this if necessary. The window can be damaged.
C:
Slot /opening between burner and mesh deco plate must be kept free of glowing material. Too
much placed glowing material can affect the combustion process.
