Operation Manual
BinTrac Breeder Control Operation Manual
Ver. 1.01 Rev 1.04
13
Part # MAN-000008
Service
Cleaning
Do not clean the BinTrac modules with a pressure washer. Use a washcloth soaked in warm water containing a mild
detergent and disinfectant.
Servicing and Repair
Your BinTrac module contains NO USER SERVICEABLE PARTS. If the product stops working for any reason, it must
be returned for repair.
Troubleshooting
There are a few types of errors that can be encountered during operation of the BinTrac. The following should give
you some insight into the cause of the error should one occur. Errors displayed are specific to the selected bin.
Error
-If this is displayed on the screen, the BinTrac is unable to display the current value or the value is
outside
the displayable range. Verify programmed settings are correct including zero or check for faulty
loadcell.
no.bin
-This means that the Smart Summing Box for the selected bin is not communicating. Check for broken
wires or loose connections, or Smart Summing Box is not correctly configured, or faulty loadcell. Inspect Smart
Summing Box internal diagnostic light; 1)flashing regular
– normal working condition, 2)off – no power
indication, 3)flashing irregular - unable to communicate.
oLOAd
-This means that the weight in the bin has exceeded the programmed system capacity by 150% and
the system is in an
over-load state. Remove the weight from the system and check the condition of each load
cell.
no.con
- This means that the Remote Display has lost communications with the host BinTrac Monitor. Check
for broken wires or loose connections and verify unit was intended for use as a Remote Display and not
accidentally misprogrammed.
no.PuL
-This error message indicates that the BinTrac Indicator has been programmed for a PULSE output
and is unable to communicate with the HouseLink WP. If not connected to a HouseLink WP, set Pulse weight
to “0”.
Error
nobin
oL0Ad
No.con
No.Pul
