MY22H03 - 32_1.0_04.10.2021
60
Assembly
5
Assembly
Assemble the pedelec in a clean, dry
environment.
The
work environment
temperature should be
between 15 °C and 25 °C.
The fitting stand used must be approved for a
maximum weight of least 30 kg.
5.1
Unpacking
The packaging material consists mainly of
cardboard and plastic film.
Dispose of the packaging in accordance with
the regulatory requirements (see Section 10).
Pedelecs are fully assembled in the factory for
test purposes and then dismantled for
transportation. The pedelec is 95% to 98% pre-
assembled.
Scope of delivery
5.2
Required tools
The following tools are required to assemble the
pedelec:
Risk of eye injury
Problems may arise if components are set
incorrectly. They may cause serious injuries to
the face.
Always wear safety glasses to protect eyes
when assembling pedelecs.
Crash and crushing hazard caused by
unintentional activation
There is a risk of injury if the drive system is
activated unintentionally.
Remove the battery.
WARNING
!
CAUTION
!
1 pre-assembled pedelec
1 front wheel
2 pedals
2 quick releases (optional)
1 charger
1 set of operating instructions on CD.
1 battery (supplied separately from the pedelec)
Knife
Ring spanners
8 mm, 9 mm, 10 mm, 13 mm, 14 mm and 15 mm
Torque wrench
Working range 5–40 Nm
by.Schulz handlebars:
TORX® bits: 4 mm, 5 mm and 6 mm
If not:
Hexagon bits: 4 mm, 5 mm and 6 mm
Hexagon socket spanner
2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, 6 mm and
8 mm
Spline nut socket
T25
Cross-recess screwdriver
Slotted-head screwdriver
Table 24: Tools required for assembly
