SERVICE MANUAL for
Telescopic pole, Gripo Alu
Telescopic pole – Gripo Alu
Side 8 av 11
2. Work Descriptions
General
It must never be changed to other parts than those stated in the split images in the ”3. PART
CATALOG” with article numbers. It can in worst case cause the product not to satisfy its
acceptance criteria, and be changed from being an aid to become a dangerous tool for the user
or the environment.
If for some reason it is desirable to deviate from this rule, Hepro has to be contacted for review
and possible approval.
2.1 Cleaning performed by user
METHODE
Normal dusting and cleaning with wet cloth and soap is sufficient.
2.2 Maintenance
2.2.1 Periodic inspection
GENERAL
It is basically sufficient with inspection when recycling. For poles older than 5 years, the
producer recommend inspection as for recycling once a year.
PRODUCTS WITH SPECIAL LOADS
The product has no particular need for periodic inspection if it is a standard product used by a
person who in any way exposes the product for special or extreme loads.
If the product is exposed to special loads, it would be an advantage for all that each case will be
considered and necessary maintenance is established.
Hepro can of course be of help with advice and guidance if contacted.
2.2.2 Preparation for reuse
To ensure that the user gets a secure aid when recycling, it is important that the aid undergo a
thorough technical control and is properly cleaned before it comes to a new user. As a
manufacturer and supplier we believe that the control described in section 2.3.2 is sufficient.
Worn parts must be checked and replaced if they are considered to lead to reduced safety for
the user.
2.2.3 Troubleshooting
The product is built quite simple, and by using the Service Manual, any error could easily be
detected.
Hepro`s Service Organization is of course also available for advice and guidance.
