Henny Penny OE-100, Technical Manual

Page: 21 / 51

2-15
Model OE-100
2-16. FILTER PUMP
REPAIR (Continued) 3. To reassemble, place rotor on drive shaft, and place rollers into
rotor.
A small amount of shortening might be needed to hold the
bottom roller into place until cover plate is put on. Make sure
O-ring is in proper position on plate.
2-17. PUMP REMOVAL 1. If the pump needs to be replaced, loosen one inch nuts from the
outflow and inflow lines. Then remove the two bolts holding the
pump to the motor with a 1/2 inch wrench.
2. The shaft seal should remain on the motor shaft, or if leaking,
should be replaced at this time.
3. To replace the pump, remove the four allen screws, front plate,
rotor, and rollers from pump (see Section 2-18). Place the pump
onto shaft and against the shaft seal. Place the two 1/2 inch bolts
through the pump and into the motor and tighten. Then replace the
rotor, rollers, front plate and tighten the allen screws.
When removing a pump from a motor, note the positions of
the INLET and OUTLET parts. Installation of the pump
on the motor in any other position could cause damage to
the fryer. There is an indicator on the side of the two halves
of the pump, this mark must be together and face to the
front of the fryer.
593