Important: Always read and follow the operating instructions. • 19
Maintenance
Instructions
Read and follow all the maintenance instructions pro-
vided in this manual to keep the machine in good op-
erating condition. Refer to the other materials received
with the unit and to the service bulletins from the man-
ufacturer for additional instructions on proper main-
tenance and service. Regular inspections and proper
maintenance are essential to preventing accidents and
injuries.
Before making any inspection, adjustment,
or repair, disconnect the power source and
block out all moving parts to prevent injury.
Keep the machine and the immediate work
area clean. Do not use compressed air to
remove dirt and debris from the machine.
Foreign material may be propelled into the
air and into operator or bystander causing
personal injury.
Wear protective clothing, equipment and
eye protection when making any adjust-
ments or repairs to the machine.
1.
The vertical and horizontal slides and the helper
slides should be cleaned with a vaporizing solvent and
then lubricated with chassis grease once a month.
2.
Check the adjustment of the Duckhead® mount/de-
mount tool once a month.
3.
The transmission in this machine is a sealed unit
packed with grease and should need no normal main-
tenance.
4.
The tabletop, clamps, steel Duckhead mount/de-
mount tool, and other working surfaces should be
cleaned with a vaporizing solvent every month.
5.
The clamps should be inspected and metal chips
and dirt removed from the serrations with a wire brush
once a month.
6.
Check the tire pressure gauge function daily, and
check the accuracy monthly. Use a pressurized tire and
a high quality stick-type pressure gauge. If necessary,
adjust the dial of the machine gauge. If the gauge is
defective, replace it immediately (part number 107985).
Contact COATS at (615) 641-7533. Check function of
the pressure limiter weekly. Always reinstall the lens
after adjusting the gauge.
7.
Make sure all fasteners are securely tightened.
8.
Make certain that all guards and covers are in place.
9.
Check for worn, damaged or missing parts including
grips and protective covers. Replace them before al-
lowing the unit to be used.
10.
On a daily basis, inspect the unit and check to be
certain that all systems are operating normally. Detailed
inspection and testing procedures are specifi ed for vari-
ous components at regular intervals. Set up a chart and
assign responsibility for these items.
Replace any damaged or missing safety decals. They
are available from COATS, (800) 688-6359.
Important
: These instructions will help you service
the unit. Instructions are for a person with some me-
chanical ability and training. No attempt has been made
to describe all basic steps. For example, how to loosen
or tighten fasteners. Also basic procedures such as
cycling systems and checking operation of the equip-
ment are not fully described since they are known to
anyone who does mechanical and service work. Do not
attempt to perform work beyond your ability or at which
you have no experience. If you need assistance, call
an authorized service center or contact COATS directly,
(800) 688-6359.
