14
5.3 Start Up the System:
1. Turn the “POWER” on (the position marked “l”
) (13). The display (3) will turn on.
2. If necessary, open the valve or regulator that controls the air inlet to supply
pneumatic pressure to the system.
3. Turn the “AIR” on (the position
)) (12).
Caution: When adjusting the pressure via
“Pressure Regulator”, always adjust
from Low-to-High. For example, to adjust from 4 bar to 2 bar, decrease the pressure
to 0~1 bar, then increase to 2 bar.
5.4 Run: Auto Mode
Engage the footswitch(s) to start the cycle. The dispensing will begin immediately
and continue until the system times out.
Notice:
Channel A and Channel B outputs are active only when the “OUTPUT” setting is set
to “ON”. (Refer to section 5.
9)
5.5 Run: Manual Mode
Press the
or
to purge the adhesive manually without displaying or saving
parameters.
5.6 Run: Continuous Mode
Engage the footswitch(s) to start dispensing and hold until the dispensing cycle is
complete. When the footswitch is released, the dispensing will end immediately.
The display on the system will show the last dispensing time. If needed, press
and
to store the dispensing time to “Run: Auto” Mode.
Notice:
Channel A and Channel B outputs are active only when the
“OUTPUT” setting is set
to “ON”. (Refer to section 5.
9)
