Hengmei PJMP2113, Operating Instructions Manual

Page: 10 / 52

Tel: +86-18615559369 Web
:
www.pellet-machine-mill.co m
E-mail: lingfengzhuri@gmail.com
- 5 -
roller from machine base side, lock the blade roller. Clean holes on press blade board and fasten bolt
forehead. Turn the rotary blade to tighten the screw (or tighten bolt), take (or press) pressed blade block
and take out the rotary blades.
(2) When rotary blades should be sharped again, must make sure of knife edge angle in Table 2, and must
adding refrigerant when sharpening.
(3) Rotary blade sharpened must adjust to size stipulated in Table 2.
( complete adjusting before leaving factory). (BX213 rotary blade adjust on blade roller).
(4) Rotary blade permission biggest sharpeed quantity may refer to stipulation in Table 2. Wen total
sharpened quantity surpasses 40mm, the bolt on the rotary blade must exchange the hexagon bolt of
M10x90 (or M10x85).
(5) Rotary blade installation sequence
A. Please clean carefully the joint placing rotary blades in the blades roller using compressed air or the
other efficacious method.
B. Install the rotary blade on the blade roller, tighten gently the two fastened bolts on both sides, tip blade
edge with the rubber hammer or the mallet, making the rotary blade back’s two adjusting bolts close to
localization bolt head on blade roller.
C. Use the torsional spanner and increased torsional equipment along with the machine to tight the rotary
blade fastened bolt according to Table 3 request.
Table 2
M odel
Rotary blade
edge angle
Rotary blade permission
sharpening quantity
（
mm
）
Rotary blade
adjustment size
（
mm
）
PJM P215 32º 35-40
157
＋
0.5
0
PJM P216 32º 60
198
＋
0.5
0
PJM P218 32º 60
233
＋
0.5
0
PJM P2113 32º 60
225
＋
0.5
0
Table 3
Model
Rotary blade bolt tight moment of
force N·m
Torsion wrench adjustment value
N·m
PJMP215 392 98
PJMP216 392 98