17
User password can be modified. To modify user password, please
refer to the “How to Modify User Password” Section.
Note:
①
After pressing down the set-up switch, the outside line will be
automatically cut off. At this time, the telephone connected with the
host via telephone extension interface is powered by the wireless
receiving host, and there should be no dialing tone, bust tone, prompt
sound or other voice signal for the telephone. If there is dialing tone,
bust tone, prompt sound or other voice signals, it means the outside
line is not be cut off. Users can hold down the set-up switch again to
enter into the set-up mode, or check if the outside line and telephone
extension line connection are normal.
②
If users continuously enter the wrong password 3 times, the
host will alert immediately, and at the same time, the original second
display zone will display “E4”, , and the dialing module will enter into
the set-up mode immediately and refuse to respond to the set-up
switch within 20 seconds.
③
When telephone line connection is completed, the wireless
receiving host gives out urgent “beep··beep··” sound prompt. If the
telephone extension socket and telephone socket are wrongly
connected, because telephone line is cut-off, this sound prompt often
occurs. To avoid this problem, please make sure telephone line is well
connected, and then set the host again.
④
In set-up mode, if users do not carry out any operation within
successively 20 seconds, the dialling module will automatically exit
the set-up mode. In this case, users must enter into the set-up mode
again to set the host.
All
All
All
All the
the
the
the following
following
following
following operations
operations
operations
operations shall
shall
shall
shall be
be
be
be done
done
done
done in
in
in
in set-up
set-up
set-up
set-up mode.
mode.
mode.
mode. And
And
And
And
press
press
press
press “
“
“
“0#
0#
0#
0#”
”
”
” to
to
to
to exit
exit
exit
exit set-up
set-up
set-up
set-up mode
mode
mode
mode once
once
once
once set-up
set-up
set-up
set-up is
is
is
is completed.
completed.
completed.
completed.
Note 1: Users can exit programming set-up mode at any time after the
host gives out prompt sound.
