Hendi 229200, Manual

Page: 7 / 128

7
EN
Connection to water supply and drainage system
Ø12.5mm x 1.5m
3/4”
Ø20mm
Ø20mm x 1.8m
18-32mm
1) Connect to water supply by means of the sup-
plied hose (Ø12.5mm x 150cm) and 3/4 “ cou-
plings. Proceed as follows:
I. Connect hose to inlet at the back side of the
machine (Location A).
II. Connect the other end of the hose to water
supply (Location B).
III. The appliance includes a water valve for con-
trolling of water flow conveniently.
2) Connect to drainage system by means of the
supplied hose (Ø25mm x 180cm) and hose
clamps. Proceed as follows:
I. Put the hose clamps onto the hose.
II. Connect hose to the joint of the junk basin
(Location C) and affixed by the hose clamps.
III. The other end of the drain hose is inserted
into the drainage system (Location D).
Operation
Attention : This appliance has a safety system
which ensures will prevent operation unless the lid
is correctly placed.
1) Open the transparent lid by pulling the handle A
until it clicks open.
2) Put the rotating plate in and load the tank with
the product to be processed.
3) Lock the lid and make sure the outlet door B is
locked.
4) Connect the water supply and switch on the
water valve. Make sure water is flowing in. (see
“Connection to water supply and drainage sys-
tem”).
5) Switch on the mains power. Power-on indicator
C will go on.
6) Start the machine by turning the timer F on the
required working-cycle time length, the operat-
ing indicator D will go on.
7) When the setting time is reached, the machine
will stop automatically and the operating indica-
tor will go off.