FIRST ENSURE THE POWER IS OFF at the main circuit breaker, and then test the wires
with a probe or multimeter to verify.
Insert the wires to the correct HE-RS01 terminals by inserting a small Phillips-head
screwdriver into the slot beneath each terminal and unscrew to open.
Follow connection diagrams on Figure 1 or 2 or 3 and the instructions below:
• Power wires:
For AC power (85-265VAC) connect Line & Neutral lead wires to L &
N terminals labeled “POWER”. For DC power (24-48VDC) connect “+” wire to terminal
L and “–” wire to terminal N.
• Source 1 wire:
Connect the required power source for relays 1, 2, and 3 to the
terminal labeled “IN 1-3”.
• Source 2 wire:
Connect the required power source for relays 4 and 5 to the
terminal labeled “IN 4-5”.
• Loads:
Connect the required loads to the relay output terminals labeled “OUT-1”,
“OUT-2”, “OUT-3”, “OUT-4”, “OUT-5”.
Note
: HELTUN recommends installing cord terminals (electric wire ferrules) on the
ends of wires before connecting them to the HE-RS01 outputs (various colors
terminals are included).
Note:
Zero-Cross technology is unavailable if the device is DC (24-48VDC) powered.
Tighten wires using Phillips screwdriver in slot beneath each wire.
Next, connect terminals S1, S2, S3, S4, S5 to external control keys (switches)
following Figure 1 or Figure 2 diagrams.
Note:
In case of using Figure 2 or 3 diagrams, it is MANDATORY to connect external
switches to the same wire connected to terminal L on the device.
Switch On the main power at the circuit breaker. The HE-RS01 will start up with the
original default factory settings and the LED indicator will blink red slowly meaning
the device is excluded from a Z-Wave network.
1.
2.
3.
4.
INSTALLATION
The HELTUN HE-RS01 Relay Switch ‘Quinto’ must be installed by a licensed electrician in a
manner that conforms to local regulations and building codes. Provide these instructions
to the licensed electrician who is installing the HE-RS01.
WARNING: Electrical power must be switched off during installation.
Summary of Contents for QUINTO HE-RS01
