2. Loosen the screw
（
M5*10) of the square part on the back of the unit. Fix the first 2 brackets
onto the square part on the back of unit and tighten the M5*10 screw.
Fix the distance from 45cm to 55cm between the two brackets.
3. Fix the other two brackets onto the wall according to the distance of the bracket on the back of the
unit. Drilling a round hole with 8mm diameter on the wall, place two 4 plastic plugs supplied into the
hole, using the ST4 * 35 screw to tighten the bracket onto the wall. Make sure the bracket is fixed
tightly and stable.
Caution:
The distance between the floor and heater should no less than 1.8m and 0.5m between the
heater and the ceiling if the unit is parallel to the floor.
4. Connect the bracket fixed on the unit back and the bracket on the wall via the connection screw
supplied. Adjust the heating angle you need.
Connection
Screw
Connection
Screw
