REMOTE CONTROL
Note: 2 x AAA batteries are not included.
The Cooler comes with a remote control for your convenience.
The functions on the remote control are the same as the buttons on the evaporative
cooler.
To install the batteries, first remove the back of the remote control by sliding the back
battery cover off.
Insert the batteries inside the battery compartment matching polarity icons with those in
the battery compartment and then refit the cover securely.
Battery Type: 1.5V 2 x AAA
Do Not mix new and old batteries in the remote control.
To prevent corrosion, remove the batteries if the remote control will not be used over a
lengthy period.
BEFORE FIRST USE
Before use, remove all packaging and inspect the appliance for any damage. If there appears to be any
damage, please take the unit back to place of purchase for a replacement.
PREPARATION
•
When ready to use the cooler, make sure that the power switch is set to OFF and the unit is
disconnected from the power point.
•
Ensure the rubber drain plug is fully inserted into the hole (located in the rear of the unit at the
bottom).
•
Remove the top cover and carefully pour clean cold water into the water tray.
•
The water will drain down through the hole into the water tank inside.
•
Fill until the level has reached the Maximum mark on the water level indicator which is located on
the lower front of the unit. DO NOT OVERFILL.
•
Ice blocks can also be added which will help cool the water/air.
•
Do Not Fill with any liquid other than clean cold water. Do Not add any additives to the water.
•
Refit the Cover before turning on.
