7
MultiZoneBox - KWL-MZB
Installation and Operating Instructions
EN
D
2 .6 Installation VOC or FTF sensor
Danger to life due to electric shock.
An electric shock can result in death or serious injury.
Ensure that the unit is disconnected from the power supply.
This must only be carried out by a qualified electrician.
− Open the unit cover (Fig.11).
− Clip the four plastic sleeves into the provided holes on the extract air side, e.g. with flat nose pliers (Fig.12/13).
− Attach the sensor board (Fig. 14).
− Insert the cable through the corner opening in the space and connect the plug to the control board (Fig.15).
− Close the unit cover again.
3 .0 Software
Download IBN software at:
https://www .heliosventilatoren .de/de/service/info-center/software
Note:
We recommend installing the commissioning software package on your laptop before the commissioning.
This will allow commissioning on site, even without internet access.
3 .1 MZB update via “MultiZone update” software
A component software update is required during the initial installation.
Connect the MZB to your PC using a USB data cable.
Start the “Multizone Update” application.
Click on the “
Establish connection via USB
”
button.
Once the box has been found, all system information will be displayed (version, date of last update).
Click on the “
Select file
” button.
This will open the Explorer and all available firmware will be displayed.
Select Helios MultiZoneBox by clicking and confirm by clicking on “
Open
”.
If a newer version (recognisable by the higher number) is displayed under update information, start the update process
by clicking on the “
Start
” button.
The update process may take a few minutes and the status is displayed by green bars.
This will be displayed in the software after completing the update.
Now end the “Multizone Update” application.
m
DANGER!
m
DANGER!
CHAPTER 3
SOFTWARE
NOTE
+
Fig .11
Fig .12
Fig .13
Fig .14
Fig .15
