EN
EN
Extension module
KWL-EM eC
for easyControls
Operating Instructions
4
m
The safety instructions in section 1�2, 1�3 must be observed!
1. Open the casing cover.
2. Slide the cable glands on the connection cable (right side el. connection cable, Mod-
bus connection cable) (left side sensor cable, power supply for accessories).
3. Thread the locknut on the cable in the terminal box and fix the cable gland.
4. Carry out the wiring according to the wiring diagram (see section 6.2/6.3) and appli-
5. Hand-tighten the cable glands.
6. Seal the remaining openings with membrane grommets.
4�2 Connection of the control board
m
WARNING
Fig�2
A
Fig�3
Terminal block 230V
Terminal block low voltage
ä
ù
ò
Summary of Contents for easyControls 3.0
