Helios AirPal Go 300 H, Installation And Operating Instructions Manual, Page: 22 / 48

Air purifier AirPal Go 300/600 H
Installation and Operating Instructions
EN EN
5
4�2�1 Chassis
• Soundproofed 30 mm extruded aluminum profile, nylon corners and pre lacquered steel sandwich panels, RAL
9006, class M0, with 25 mm internal rockwool insulation class A1 (non-combustible) and 90 kg/m³ density. Panels
come with quick release fastening system for easy assembly and disassembly whenever required, whether for
cleaning, maintenance or panel repositioning.
• Filters are located in the perforated side panels, with handles and fastening system. This ease of
access optimizes maintenance and filter replacement procedures. Filter replacement and manipu-
lation of the air purifier AirPal Go 300/600 H is recommended with the appropriate PPE’s. See „8
MAINTENANCE AND SERVICE“ on to change the filters and their correct and safe handling.
• Air purifiers AirPal Go 300/600 H are equipped with 4 wheels with brakes on the base for ease of mobility throug-
hout the interior spaces. The wheel set is included with the product, these need to be fixed to the body of the unit
on the aluminum supports before use.
4�2�2 Fan
• Equipped with high efficiency single inlet – self cleaning backward curved impeller, made of polyamide, statically
and dynamically balanced at the factory
4�2�3 Filters
• The air purifier AirPal Go 300/600 H is equipped with a two stage filtering at each air intake; 4 filters in total are
included 2 un +2 un:
2 un x ISO COARSE 65% (old G4) Pre-filter stage to protect from dust and dirt and improve the shelf life of the
main or absolute filter
2 un x HEPA H14 Main filtering stage of high or absolute efficiency
4�2�4 Motors
• The models AirPal Go 300 H and AirPal Go 600 H are equipped with a low consumption EC (electronically commu-
tated) exterior rotor motor. IP-44 protection and class B insulation. Standard voltage 230V 50Hz/60Hz
4�2�5 Control panel
• All air purifiers AirPal Go 300/600 H are equipped with a master control panel located on top of the structure.
5�1 Assembly of the wheels
The air purifier AirPal Go 300/600 H comes with a kit containing 4 wheels to allow easy relocation of the unit. Before
use, the wheels must be attached to the structure of the unit by means of screwing them into the mounting locations
(M8 thread).
m
IT IS MANDATORY TO ATTACH THE WHEELS TO THE UNIT BEFORE OPERATION� Otherwise the air
purifier AirPal Go 300/600 H is unable to return the filtered air to the room as the discharge is within the base
of the unit�
m
The air purifier AirPal Go 300/600 H should only be operated in the vertical position with the fan at the
bottom�
Do not lay the appliance flat or turn it upside down for use� The wheels placement is a guideline of the proper
equipment position�
5�2 Connection cable
The air purifier AirPal Go 300/600 H has a connection cable to plug in to the mains electricity. If it comes separated
from the set, pre-connect the universal connector to the equipment slot and plug it in normally. An
ON/OFF
switch is
located on the control panel.
CHAPTER 5
FIRST COMMISSIONING
ATTENTION