Air purifier AirPal 1750/2200 H
Installation and Operating Instructions
EN
EN
7
- Position the unit in the final position, observe minimum clearances, see chapter 3.2 on page 6.
- There 2 nuts on an adjustable foot, whereby one is accessible from outside and another is inside the unit (Fig.5,
- To raise the unit, firstly, turn the inside nuts counter-clockwise and then tighten the outside nuts. To lower the unit
firstly turn the outside nuts clockwise and then tighten the inside nuts.
To access the nuts inside the unit, you may need to replace the filter� Please follow the instructions in section
5�3 on page 12�
Change the height of the feet to level the device. Height “H” can be max. 125 mm (Fig.7).
3�3 Fixing to the wall
m
Risk of personal injury and equipment damage!
Make sure that the device is placed on a flat surface and it is fixed properly to wall before any assembly work.
Use the bracket supplied with the assembly kit to fix the unit to the wall or a similar flat rigid surface using the 2 fixing holes on
the rear panel (Fig.8).
Fig�6
ATTENTION
Fig�7
m
DANGER
Fig�8