Installation instructions Art. no. 36840
Page 2 of 3
Last revision 06.2014
Installation:
This product must only be installed by trained electricians.
We recommend that you install a severable connection between the luminaire and the mains supply
directly on the luminaire. Suitable for this purpose is a watertight and unscrewable socket sleeve for
cable connections.
Prior to installation, make sure the connection lines installed in the building are de-energised and
secured against switching back on. To do so, trigger the in-house automatic circuit breaker and prevent it
from being switched back on.
When installing the floor-mounted luminaire outdoors, secure the outdoor luminaire with a ground fault
circuit interrupter. Follow all installation regulations applicable at your location. For some locations it is
absolutely necessary to install a ground fault circuit interrupter.
The floor-mounted luminaires are pre-assembled.
Follow all applicable safety information and warnings and install the floor-mounted luminaires in the
desired location. Make sure no water can accumulate at the installation location.
The minimum distance to the illuminated objects must not be lower than 0.5 m.
After positioning the plastic floor housing at the desired location, make sure the pot for floor installation is
safely connected with the subsurface.
Remove the stainless steel cover along with the safety glass. Route the wiring cable through the cable
entry point installed at the bottom of the luminaire.
Connect the connection lines at built-in ground spotlight to the junction box in the building . Connect up
the yellow-green ground wire first of all and then the other two lines. The brown (or black) cable is
usually the phase conductor, connect this to the terminal marked with an "L". The blue conductor must
be connected to the terminal marked with an "N".
Check again if the components are properly connected.
Re-attach the socket in the luminaire housing and screw the cable entry point tight.
Continue by inserting the floor-mounted luminaire into the plastic floor housing. Make sure the luminaire
is mounted tightly and securely.
Re-install the safety glass and the stainless steel cover. Make sure that the cable entry point and the
gaskets are free of any dirt and impurities.
Switch the in-house automatic circuit breaker back on again.
When installing the floor-mounted luminaires and laying the cables, pay attention to any obstacles that
may increase the risk of stumbling on walkways.
Do not remove the nameplate.
Changing the illuminant:
The use of other illuminants may cause the lamp to overheat.
Disconnect the power supply before changing the illuminant.
If you are replacing the illuminant immediately after the light has failed, wait until the light has cooled off
sufficiently.
Unscrew the stainless steel cover from the housing and remove the glass pane.
Carefully remove the defective illuminant from the socket. Carefully insert the new illuminant and screw it
into the socket. Do not apply too much force or pressure.
Screw the stainless steel cover including the glass pane back onto the housing. Make sure that the
contact surfaces on the gasket are clean. Any impurities may lead to leaks and cause the floor-mounted
luminaires to malfunction.
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
