13
GASOLINE TILLER
return to work in the area unless you have properly ventilated area and have clear that ventilation is
sufficient so that does not happen this concentration again.
•
Work only in daylight or good artificial light. Do not use this machine at night, with fog or with a low
visibility which do not allow you to clearly see the working area.
•
Limit continued use of this machine to a 10-minute time limit and between 10 and 20 minutes to rest
between each session.
•
If you slip or fall, stop acceleration and move the
switch to the “STOP” position.
•
Do not use this machine if you are tired, ill, have taken drugs, narcotic drugs or alcohol. The lack of rest
and fatigue can cause accidents or damage.
•
Always readjust the machine on a flat and stable surface.
•
Do not use the machine on steep slopes where you cannot guarantee their safety. If you are working on
slopes slow down your work pace and ensure you have good stability.
•
Be alert when you back up or pull the machine towards you.
Do not solely rely on the security features of this machine.
•
It is necessary to pay attention to the possible loosening or overheating of the parts of the machine. If you
detect any anomaly immediately stop the machine and check it carefully. In case of mechanical failure
take the machine to the technical service for repair. You should not continue working if you notice that
the operation is not correct.
•
Remember to always use the machine with clean hands and without any fuel or oil remains.
•
Clean the work area and remove all obstacles that may cause accidents. Check the work area when going
to work and remove all items that could become entangled in the cutting tool. Also remove all the objects
that the cutting tool can violently eject in the operation.
•
Do not allow anyone to enter the work perimeter. This work perimeter must be 15 meters and is a danger
zone.
•
Never leave this machine unattended.
Be careful not to touch the hot parts of the machine while the engine is running or after use, such
as exhaust, spark plug or high voltage cables.
•
Do not use other accessories this machine except those recommended by our company since its use could
cause severe damage to the user, people close to the machine and the machine itself.
•
Always follow the safety rules given in this manual.
7.1. HOLDING AND GUIDING THE MACHINE
While working always place yourself behind the machine and hold it firmly with both hands
on the handles.
Warning!
Do not solely rely on the security features of this machine.
Warning!
This rotary tiller could bounce upwards or jump forwards unexpectedly. If the teeth hit
something hard that is buried in the ground such as large stones, roots or trunks, if the soil is too hard or if
the ground is frozen. Always firmly hold the machine with both hands.
•
This machine clutch is deactivated (disengaged) by default. To activate the clutch
and for the engine power to transmit to milling cutters, the clutch lever must be
tightened.
•
The clutch lever has a security block that avoids the accidental clutching of the
machine.
•
To act on the clutch, we firstly must remove the security blockage moving with
one finger the blocking device (w1) downwards and without letting go, pressing the clutch lever (w2).
7.2. WORKING WITH THE ROTARY TILLER
•
Start the machine following the instructions in the manual.
•
Milling cutters in motion will pull the machine forward, you must maintain the appropriate speed more
or less by nailing the spur in the soil.
•
Slowly move the tiller at the right rhythm so the milling cutters have time go crumbling the land.
