12
GASOLINE TILLER
The cutting tool should be off by default to prevent the machine from moving at the time of starting the
machine. To verify that the clutch is disengage, place
the switch to “STOP” position and pull slowly and
forcefully from the Starter handle the engine turn. Note if, while the motor spins, also turn the cutting tool.
If the cutting tool rotates, it means that the clutch is engaged and is therefore poorly regulated. If the clutch
is not correctly regulated take your machine for service.
6.4.2. STARTING THE ENGINE
Start the engine carefully, in accordance with the instructions, and feet away from the milling cutters.
6.4.2.1. COLD-STARTING THE ENGINE
Place the machine on a flat surface and stable to start it.
- Place the throttle lever in the closed position .
- Place yourself behind the machine, as shown in the figure, and pull the starter rope
until the engine starts.
- If the machine starts and does not stop, slowly begin moving the accelerator toward the open air position
.
- Adjust the appropriate number of revolutions with the throttle lever.
- Allow the engine to warm up for a few minutes before starting to use the machine.
6.4.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat surface and stable to start it.
- Place the throttle lever in the position
.
- Place yourself behind the machine and pull the starter rope until the engine starts.
- Adjust the appropriate number of revolutions with the throttle lever.
6.4.2.3. STOPPING THE ENGINE
- Place the throttle lever in positions the minimum speed
and allow the engine to remain idle seconds.
-
Place the accelerator in the “STOP” position.
6.4.3. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible individual parts or and the temperature of the machine. If
you detect any anomaly in the machine immediately stop and check it carefully. In case of any malfunction
or problem take the machine to a service technician to be repaired. In any case continue to use the machine
if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly adjusted.
7. USING THE MACHINE
Use this machine only for the designated purposes. Using this tiller for any other use is dangerous and
can cause bodily harm and/or damage to the machine.
Do not approach the milling cutters of the rotary tiller when the motor is running.
Do not start the machine in a room or enclosure. The exhaust gases and fuel and oil vapors contain
carbon monoxide and harmful chemicals. In case of a concentration of gases produced by poor
ventilation, remove all that impedes the flow of clean air to improve ventilation from the work area and not
