9
CORDLESS DRILL
8.4.2 Metal drilling
Support thin material with a piece of scrap wood. Use a center punch to mark the position of the hole. If
drilling a large hole, use a small size drill bit first to establish a pilot hole then use the required large size drill
bit. Use only HSS (High Speed Steel) drill bits or those recommended for metal use. When drilling into iron
or steel, use no lubricant but withdraw the drill regularly to assist cooling.
8.4.3 Wood drilling
Mark the place where you want to drill with a punch or a nail. To avoid splintering on breakthrough, either
clamp a piece of scrap wood to the back of your work piece or continue the hole from the back of the wood
when the drill bit first breaks through.
9. MAINTENANCE
9.1 General
Your tool has been designed to operate over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool care and regular cleaning. Clean your tool
using a damp cloth.
Your charger does not require any maintenance apart from regular cleaning, unplug it before cleaning.
Use a soft brush or dry cloth.
KEEP VENTILATION SLOTS CLEAN! Periodically check the air vents for dust or other debris. Clean with
compressed air (max. 3 bar)
Do not use any abrasive or solvent-based cleaner. Use clean cloths to remove dirt, carbon dust, etc.
WARNING: Do not allow brake fluids, gasoline, petroleum-based products, penetrating oils, etc. come in
contact with plastic parts, they contain chemicals that can damage, weaken or destroy plastic.
WARNING: Always wear safety goggles or safety glasses with side shields when using compressed air to
clean tools. If the operation is dusty, also wear a dust mask.
BATTERIES: The battery pack for this tool is equipped with a Ni-Cd rechargeable battery. Do
not disassemble battery pack and attempt to replace the batteries inside.
9.2 Service
Have your power tool serviced by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
10. STORAGE
Store your tool in a clean, dry, frost free environment.
Battery storage
Store your batteries in a cool area. Never store batteries in discharged condition.
It is better for batteries to recharge them frequently.
11. TECHNICAL DATA
Rotation Speed
0-550 / 0-1000 min-1
Max. drill-bit diameter
10 mm
Rated voltage DC (Un)
18 V
Summary of Contents for VMGA003
Page 11: ...11 CORDLESS DRILL...
