Heinner HWM-V7012A++, Manual

Page: 37 / 86

www.heinner.com 7Kg, 220-240V~50Hz, 1200rpm
36
FAULT POSSIBLE CAUSE TROUBLE- SHOOTING
Unsatisfactory washing
result.
The contamination degree of
your laundries does not match
the programme you have
chosen.
Select the programme appropriate for
the contamination degree of your
laundries. (See programme table)
Amount of detergent used
insufficient.
Adjust the amount of detergent based
on the amount and contamination
degree of your laundries.
Laundries in excess of
maximum capacity put in
your machine.
Load your machine with laundries,
amount of which will not exceed
maximum laundry capacity.
Unsatisfactory
washing result.
Water being hard.
( Contaminated, lime water
etc.)
Adjust the amount of detergent based
on the instruction of detergent
manufacturer.
Laundries distributed in your
machine non- homogenously.
Spread your laundries in the
machine properly and
homogeneously.
As soon as the ma-
chine is loaded with
water, water dis-
charges.
The end of water
discharging hose is too low
for the machine.
Set the water discharging hose on
appropriate height.
No water appears
in the drum during
washing.
No fault. Water is in the
unseen part of the drum.
Laundries have
detergent residues
on them.
Non-dissolving particles of
some detergents may stick
to your laundries as white
spots.
Perform an Extra rinse by setting your
machine to “Rinsing” programme, or
clean the spots using a brush after
your laundries dry.
Grey spots appear
on the laundries.
The reason for such spots may
be oil, cream or ointment.
Apply the maximum amount of
detergent instructed by the detergent
manufacturer in the next washing
operation.