Heinner HWM-5080E, Manual

Page: 47 / 136

www.heinner.com
XV. Cleaning and maintenance
Cleaning and Maintenance of Washing Machine Cabinet:
Proper maintenance on the washing machine can extend its working life. The surface can be cleaned
with diluted non-abrasive neutral detergents when necessary. If there is any water overflow, use the wet
cloth to wipe it off immediately. No sharp items are allowed to strike the cabinet.
Note: Formic acid and its diluted solvents or equivalent are forbidden.
Cleaning internal drum
The rusts left inside the drum by the metal articles shall be removed immediately with chlorine-free
detergents.
Never use steel wool.
Dispose a Frozen Washing Machine

When the temperature drops below zero and your washing machine gets frozen, you may:
1. Disconnect the power supply for the washing machine.
2. Wash the tap with warm water to loosen inlet pipe.
3. Take down inlet pipe and immerse it in warm water.
4. Pour warm water into washing drum and wait for 10 minutes.
5. Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Note: When the washing machine is reused, make sure the ambient temperature is above 0 °C.
Anti-freeze:

If your washing machine is located in the room where it can get frozen easily, please drain the
remaining water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1. Close the tap
2. Screw off the inlet pipe from tap and put its end into the container.
3. Start up any procedure except single Wash or Drain procedure. Water will be drained out of inlet
pipe if any for about 40 seconds.
4. Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump.
Warning!!! To avoid burning, it shall be done after the hot water inside the machine cools down.
46