www.heinner.com 120W, 220-240V, 50Hz
V. USING INSTRUCTIONS & CLEANING GUIDANCE
Note: Water reservoir and pipeline should be well cleaned before use.
Step 1. Open the lid and take out the ice basket to add appropriate water into water
reservoir.
Note: The water poured into water reservoir should be lower than the water
reservoir’s MAX position. When water volume goes beyond the max, please open the
bottom water drain plug to drain the spare water out. Then close the transparent lid.
Step 2. Plug in the power and press the
“
ON/OFF
”
button to start the machine
Note: For the first three cycles, the ice may be small and irregular in size.
Note: When the ice collecting tray is full please remove the ice immediately, Do not
allow the ice collecting tray to overfill.
CLEANING
1. Clean the inner liner, ice collecting basket, water box, ice shovel and evaporator
frequently. When cleaning,unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of the Ice
maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline
or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have enough
water to pump for air retard, and the indicator of “ADD WATER” will keep lighting. At
this time, you just need to press POWER button again, the machine can enter normal
state.
4. To ensure the cleanness of ice, please change water for water reservoir at least
once one day. If do not use for a long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully water or
interruption of power supply, it will delay for 3mins to start up after restarted.
6. Always use fresh water before starting ice production either at initial installation
or after a long shut-off period.
