25
Gas connection
WARNING: Before starting any work related with gas installation, turn off gas supply. Risk
of explosion.
Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push one of the hose until it goes to the end of the pipe.
2. For the sealing control; ensure that the buttons in the control panel are closed, but the
gas cylinder is open. Apply some soap bubbles to the connection. If there is gas leakage,
there will be foaming in the soaped area.
3. The oven should be using a well ventilation place and should be install on flat ground.
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the counter level. Bring it to
the counter level by adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of your oven go through the heated areas,
especially through the rear side of the oven. Do not move gas connected oven. Since the
forcing shall loosen the hose, gas leakage may occur.
7. Please use flexible hose for gas connection.
Note: the regulator to be fixed on LPG cylinder should have 300mmss feature.
For natural gas connection:
2.
For LPG (cylinder) connection, affix metal
clamp on the hose coming from LPG
cylinder. Affix an edge of the hose on
hose
inlet
connector
behind
the
appliance by pushing to end through
heating the hose in boiled water.
Afterward, bring the clamp towards end
section of the hose and tighten it with
screwdriver. The gasket and hose inlet
connector required for connection is as
the picture shown below
Main gas pipe
Gasket
Hose inlet connector
Metal clamp
Lpg connection
WARNING: Natural gas connection should
be done by authorized service.
For natural gas connection, place gasket in
the nut at the edge of natural gas
connection hose. To install the hose on
main gas pipe, turn the nut. Complete the
connection by making gas leakage control.
Main gas pipe
Gasket
Nut
Natural gas
Connection hose
