www.heinner.com 850W, 50Hz, 220-240V
5
MAKING FROTHING MILK/CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frohed milk.
Method:
1.
Prepare espresso first with container big enough according to the part
“
MAKE ESPRESSO
COFFEE, make sure that the steam control knob is at the
“
o
”
position.
2.
Press the coffee/steam selector to the “
” position, the lamp in the pump control
switch will be illuminated, wait for until the indicator in the coffee/steam selector is
illuminated. Note: During operation, the indicator in the coffee/steam selector will cycle
on and off to maintain the desired temperature.
3.
Fill a jug with about 100 ml of milk for each cappuccino to be prepared, it is
recommended to use whole milk at refrigerator temperature (not hot!). Note: In
choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear
in mind that the milk increases in volume by 2 times, make sure the height of jug is
enough.
4.
Turn the steam control knob slowly anti-clockwise, steam will come out from the frothing
device. Note: Never turn the steam control button rapidly, as the steam will accumulate
rapidly in short time which may increase the potential of the risk of explosion.
5.
Insert the frothing device into the milk about two centimetre, froth milk in the
way-moving vessel round from up to down.
6.
When the required purpose is reached, you can turn the steam control knob to “o”
position. Note: clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
7.
Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten
to taste and if desired, sprinkle the froth with a little cocoa powder.
8.
Press the Power switch to the “
” position to cut the power source off. All indicators
will be extinguished.
MAKING STEAM
The steam wand can be used to make hot beverages like drinking chocolate, water or tea.
Method:
1.
Open the top cover, remove the detachable tank and fill it with desired water, the water
level should not exceed the “MAX” mark in the tank. Then place the tank into the
appliance properly.
2.
Replace the top cover, then connect the appliance to power supply.
3.
Press the power switch to the “
”
position, it’s lamp is illuminated.