Heinner HEM-1100BK, Manual

Page: 9 / 79

www.heinner.com 1100W, 50Hz, 220-240V
8
8. Pour the frothed milk into the espresso prepared, now the cappuccino is ready.
Sweeten if desired, sprinkle the froth with a little cocoa powder.
Note: after steaming, we recommend you allow the maker to cool down at least for 5 min
before making coffee again. Otherwise burnt odor may occurred in your Espresso coffee. If
you want to make coffee immediately, follow the next steps: First, press and release the
steam/coffee button to the higher position; dip the steam wand into a cup; secondly, press
the pump control button down to the lower position and turn on the steam control knob and
there will be water flow out from steam wand and funnel; after the ready indicator
extinguish, press and release the pump control button to the higher position, then turn the
steam control knob to minimum position. When the ready indicator illuminate, you can start
to brew coffee again.

Frorhing milk/ producing steam to heat liquids:
The steam wand can be used to froth milk and make hot beverages like drinking chocolate,
water or tea.
1. Remove the removable tank and fill it with desired water, the water level should not
exceed the “MAX” mark in the tank. Then insert the tank into the appliance properly.
2. Then connect the appliance to power supply.
3. Press down the ON/OFF button “ ” to turn on the unit, the power indicator (red)
illuminate.
4. Press down the pump control button to the lower position which is the “ ”
position, make sure the coffee/steam button is at the higher position which is the
“ ” position, the pump will pump water, when there is water flowing out, close the
pump immediately.
5. Press down the coffee/steam button to the lower position which is the “ ” position
and wait a moment, the appliance begins to heat until the green lamp illuminate, it
means the heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the
steam wand about 2 centimeters into the milk. Turn the steam control knob in
anti-clockwise slowly to start making steam.
7. Then the desired result is got, you can turn the steam control knob to the minimum
position.
8. Press and release the ON/OFF button “ ” to cut off the power source.
9.