Heinner HEM-1100BK, Manual

Page: 6 / 79

www.heinner.com 1100W, 50Hz, 220-240V
5
Note: There may be noise when pumping the water for the first time, it is normal, as the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.

Pre-heating:
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance
before making coffee, including the funnel and cup, so that the coffee flavour will not be
influenced by the cold parts.
1. Remove the removable water tank and fill it with desired water, the water level should
be between the “MAX” mark and the “MIN” mark in the tank. Then insert the tank
into the appliance properly.
2. Set steel mesh into metal funnel, then insert the funnel into the appliance from the
“INSERT
→
” position, and you can fix them into coffee maker firmly by turning it
anticlockwise until it is at the “
∣
” position. (See fig. 1).
3. Place an espresso cup you have prepared on removable cup shelf.
4. Then connect the appliance into power supply. Make sure the steam control knob is at
the minimum position.
5. Press the ON/OFF button “ ” to turn on the unit, the power indicator (red) will
illuminate, make sure the “ ” and “ ” button is on the higher position.
6. Press down the pump control button to the lower position which is the “ ” position,
when there is water flowing out, close the pump immediately by pressing the pump
control button again to the higher position of “
”. The purpose of the step is to
pump the water of the tank into the housing.
7. When the ready indicator (green) is illuminated, you should press down the pump
control button to the lower position which is the “
” position again, there will be
hot water flowing out.