www.heinner.com 750W/1500W, 220-240V~50Hz
SYMBOL FUNCTION
THERMOSTAT
Turn clockwise to increase the heat output.
OPERATION
Plug the heater into a suitable power outlet [observing all the instruction regarding
positioning and switch on.
To use the fan only function:
Turn the control dial to
“ ”
. The fan will blow out air at room temperature.
If the fan does not operate, the ambient room temperature is cooler than the built-in
thermostat
“
OFF
”
level. Turn the thermostat dial gradually clockwise and the fan
will start blowing.
As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating:
Turn the control dial to
“
I
”
for low heat and
“
II
”
for full heat.
Set the level of heat by turning the thermostat dial gradually clockwise for the lowest
heat and fully clockwise for maximum.
The thermostat will turn the machine off when the selected room heating is achieved,
and when the temperature drops it will turn on again automatically.
For maximum heat output use
“
II
”
with the thermostat turned fully clockwise.
OVERHEATING
The thermostat will turn the machine off it overheats.
Overheating can be caused by obstruction to the air intakes on the back of the
machine or the grill on the front .If this occurs please disconnect the machine and
allow it to cool for 30 minutes. Remove any obstruction and turn the machine back
on.
SAFETY TIP-OVER SWITCH:
The appliance is fitted with a tip-over switch. When you use the appliance in an
upright position on a flat and stable surface, the tip-over switch will be on. In the
event the heater is knocked over, the heater will stop functioning automatically.
IV. USING THE APPLIANCE
OFF
Fan only, no heat
Low heat output
Full heat output
