Heinner CH-201SS, Instruction Manual

Page: 23 / 60

www.heinner.com 85W, 50Hz, 220-240V
22
BULB REPLACEMENT
The bulb must be replaced by the manufacturer, its service agent or
similarly qualified persons.
Always switch off the electricity supply before carrying out any operations
on the appliance. When handling bulb, make sure it is completely
cooldown before any direct contact to hands.
When handling globes hold with a cloth or gloves toensure perspiration
does not come in contact with theglobe as this can reduce the life of the
globe.
Note:
Before changing the lights, make sure that the appliance is plugged off.
Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
• Remove the filter.
• Loosen the 2pcs ST4*8mm self -tapping screw from the lighting panel, take out the
lighting fixture.
• Disassembly the 3pcs ST3*12mm screws on the terminal box cover and take down
the wire cover.
• Pull out the terminal from the PCB terminal block, disconnect the wire connector and
replace the lamp.
• ILCOS D code for this lamp is: DBS-2/65-H-120/33
– LED modules – rectangle LED lamp
– Max wattage: 1×2 W
– Voltage range: AC 110-240V
– Dimensions: