Heiniger Xperience/C, Translation Of The Original Instructions

Page: 30 / 220

12
Translation of the original instructions / Cattle clipper Xperience
Fig. 3
X
If the clipping quality deteriorates,
increase the clipping pressure by
turning the adjusting knob another
1/4 turn in the direction of the arrow.
If this does not produce the desired
result, the shearing blades must be
replaced or sharpened.
NOTE!
X
If the clipping pressure is too low, hair can gather between the
shearing blades. This results in a poor clipping quality. In this
case, clean the clipping blades as described in chapter 6.7.
6.3 Switching the clipper on and off
I
0
Fig. 4
X
To switch the clipper on, slide the
ON/OFF switch to the position I.
X
To switch the clipper off, slide the
ON/OFF switch to the position 0
(see Fig. 4).
6.4 Using the clipper
X
Approach the animal from the front.
X
Secure the animal to be sheared and calm it down.
X
Plug the power plug into the socket.
X
Switch the shearing machine on while you are in the visual range of the
animal.
X
Observe the animal's behaviour while clipping.
X
Switch the clipper off after you have finished clipping and pull the plug
from the socket.
6.5 Replacing the clipping blades
Fig. 5
X
Switch the clipper off by sliding the
switch to the position "0".
X
Pull the plug from the socket.
X
Turn the adjusting knob in the
direction of the arrow until the
resistance decreases.
X
Place the clipper with the comb plate
screws facing upwards on a flat
surface.