Heckert Solar NeMo 3.0, Installation And Operating Manual

Page: 5 / 17

5
Figure 2: Picking packaging: Pallet with 19 modules or fewer
Exercise caution when working with the modules!
 Carry the modules with both hands. Do not use the connection sockets or cables(s) as a handle. During the
transport and installation, take care that no pressure or tension is exerted on connection sockets and cables.
 Protect the modules from any hard knocks! Do not set the modules down roughly on hard ground. Do not set
the modules down on their corners. Do not place the modules on top of each other unprotected. Do not place
any objects on the modules.
Never stand on the modules! Do not allow the modules to fall or use hard or
pointed objects on them.
 Special care must be taken to connect the modules in accordance with the instructions and should not be
forced. Keep all electrical contacts clean and dry.
 A dry, well-ventilated room should be used to store the modules if necessary.
 For the system documentation, it is advisable to make a note of the serial number and address of the place of
installation on the installation plan.
 Do not install any damaged modules.
Please observe the specific instructions for handling solar modules with AR glass.
Compared with non-coated glass, the surface of AR glass has a similar resistance to mechanical or chemical influences
and should be handled with a similar level of care. However, due to its special reflective properties, light soiling is more
visible than on non-coated glass. In particular, fats and oils are already visible in small quantities and may influence
transmission. In order to avoid hand prints, the modules should only be touched with clean gloves.
4. Information on the module
Certification and Performance Data
For the performance data and instructions on certificates for our brand modules, please refer to the datasheets for
the respective series.
Use
Please observe the following points in particular for the use of our brand modules:
 The installation or operation of the solar modules is permissible up to an altitude of max. 2000 m above sea
level.
 The function of the modules is tested at an ambient temperature of -40 to +40°C. This area should be adhered
to.
 The solar module is not saltwater-resistant (recommended distance from the sea: 500 m).
 The module must not be subjected to unusual chemical loads (e.g. emissions from manufacturing plants).
 Do not immerse the solar module in liquid.