Table Layout
The approximate number of heaters required to heat a common residential table setting is given below.
1x TF2200RW
2x TF2200RW
Safety
The TF2200RW has an IP rating of X4. This means it is protected against water splashed from all directions but
limited water ingress is permitted.
The TF2200RW has undergone extensive testing both in laboratory conditions, in Thermofilm
’
s manufacturing fa-
cility and field trials in Australia and overseas. It is this testing that gives the purchaser the confidence of a high
quality product.
Independent laboratory testing has confirmed Thermofilm
’
s full compliance with Australian and New Zealand
standards.
TF2200RW is Class 1 equipment and must be earthed.
In operation, this heater is VERY HOT—
do not touch any part of the heater while it is turned on. Do not touch any
part until 30 minutes after it is turned off.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or intellectual
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do
not play with the appliance.
Do not allow any cables, furnishings, flammable materials or other items come in contact with any surface of the
heater.
If installed in wet areas, the heater switches or controls must be located so that they cannot be touched by per-
sons in the bath or shower.
The heater needs to be installed as per the installation instructions paying special attention to the minimum clear-
ances. The heater needs to be mounted on a rigid bracket or fixing.
The heater must not be mounted immediately below or in front of a socket outlet.
