2
1.1 Introduction
This instruction manual descr
ibes the Heatstore
Surface Warm Air Ceiling Heaters.
The heater is designed to be suspended from the
ceiling.
1.2 General
All installations must be in accordance with the
regulations in force in the country of use.
These instructions must be handed to the user on
completion of the installation.
Installers and service engineers must be able to
demonstrate competence and be suitably
qualified in accordance with the regulations in
force in the country of use.
To ensure continued and safe operation it is
recommended that the appliance is serviced
annually.
The heater outlet / inlet must not be obstructed
during use.
1.3
Electrical Supply
Electrical supply is 230/240V single phase,
Neutral and Earth. The maximum cable inlet size is
4mm².
It is recommended that the electrical supply to the
base unit in the heater is via an appropriate
switched isolator in accordance with the
regulations in force in the country of use and must
be via a fused isolator having a contact separation
of greater than 3mm on all poles.
BMS control, time switches, room thermostats and
door interlocks can be installed at the discretion
and responsibility of the installer.
All units must be wired in accordance with I.E.E
regulations for the Electrical Equipment of
Buildings and the installer should ensure that a
suitable isolating switch is connected in the mains
supply.
1.4 Controller
RF
models
The HSSCH3000RF and HSSCH4500RF will only
operate when paired and controlled by the RF
range of wireless controllers shown above.
1.6 Location
All units should be installed horizontally. It is
recommended that the ceiling heater is
suspended using four 10mm rods.
Care must be taken to allow complete free air
movement into the inlet grilles of the unit to
ensure the correct working operation of the
heater. If the HSSCH3000RF and the HSSCH4500RF
heaters are mounted close to the wall or corner
the discharge opening should be facing the
wall. The minimum distance from the wall
.
1.7 Clearance distances
It is acceptable for the heater to sit flush to the
ceiling.
The minimum mounting height (floor to grille) is
2.2m for the HSSCH3000RF and the HSSCH4500RF
The recommended mounting height is 2.5m for
the HSSCH3000RF and the HSSCH4500RF
Heatstore RF Wireless Controllers
HSPBRF
HSTIRF
HSVTRF
1
.
General Information
