Mounting
To wall mount, the wall bracket supplied must
be used
.
Please refer to illustrations in Fig.1.
Remove wall bracket from the heater. Fix wall
bracket to wall using screw holes provided.
Present heater to bracket. Locate heater onto
bottom lugs via 2 sets of relevant slots in rear
panel. Hinge heater upwards and locate the
top tabs into the slots in the back of the heater
and ‘click’ into position
.
To remove the heater from the wall first
disconnect the power then press down on the
two top tabs to release the heater. Hinge the
heater forward on the bottom lugs. The heater
can be now lifted off the bottom lugs to
remove it from the wall.
The heater must not be located immediately
below a fixed socket outlet
.
Controls
When the appliance is connected to the
mains supply, the LED indicator will light up
green, showing that the power is available
to the unit.
When the heat output has been enabled
by a controller, the LED indicator light will
turn red.
Operation
This heater can only be used when
connected to any
RF
wireless controller.
Each
RF
controller can control any
number
of heaters providing they are in the RF
range.
RF
wireless controllers
Please refer to the
RF
installation and
control guide for full operational details.
HSPBRF
HSVTRF
HSTIRF
C
USTOMER
H
ELPLINE
Should you need any advice on the use of your new
Heatstore
product, or should you require service
or repair, please contact our Helpline:
Heatstore
Unit 12, Access 18, Bristol BS11 8HT
Tel: 0117 9235375 Fax: 0117 9235374
Web: www.heatstore.co.uk
4
