4
3.0 INSTALLATION - WALL MOUNTING
3.1
Using Diagram 2 and the Dimensions Table as a guide mark the position of the
wall mounting bracket and lower location point. Drill and plug the wall with
suitable fixings, fix the wall bracket to the wall.
3.2
Fit the heater wall bracket to the rear of the unit using the screws provided
ensuring the central location bolt is pointing towards the bottom of the unit.
3.3
Remove the backing paper from the self adhesive pads of the Levelling Feet and
affix them to the lower back of the unit in the approximate positions shown on
Diagram 3.
3.4
Hang the unit on the wall mounting bracket ensuring the location bolt locates in
the hole in the wall bracket. Position the moulded spacer block between the tab
on the bottom cover moulding and the wall. Insert a No. 10 x 2 1/2long screw
through the tab and spacer block and tighten into wall plug.
2.5
NOTE: Ensure that the wall can support the full weight of the unit (see TECHNI-
CAL SPECIFICATIONS) and that there are no hidden services (electricity, gas, or
water) below the surface of the wall.
2.6
DO NOT install where the unit may freeze.
50 Litre
30 Litre
Dim ens ion
888
616
A
937
665
B
1060
788
C
678
506
D
Diagram 2
Dimensions