7
6
2.7 The bracket bolted to the CASE BACK of the Supreme uses the
M10 x 20 set screws (2 off) supplied. The small, slotted, CASE
BACK bracket is secured in position with No. 8 x ½” screws
(supplied). Note orientation and slot in the case anchor strap
before fitting screws (Fig. 1).
2.8 Fit the 2 metal and black plastic stabilisers to the M6 threaded
inserts (on the back of the unit 130mm above the base) and
screw fully in.
2.9 Remove the bottom cover by unscrewing the 3 fixing screws,
lowering the front edge and lifting away the stainless plate. Lift
and hang the Supreme onto the wall mounting bracket. Screw
the stabilisers out to just touch the wall and then secure the case
anchor strap to the wall (confirm suitability of 1 ½” x No. 12 screw
and 2” plug for use with the wall. If unsuitable due to wall type
provide alternative fixings).
3.0 INSTALLATION - TAPS
3.1 Remove the tap bezel by unscrewing the 2 screws. Check that
tap boss thread and bore are clean. Remove lock nut from tap
shaft, pass tap shaft through bezel and refit lock nut, take care to
locate lock nut as far up the shaft as possible. Lubricate ‘O’ ring
seal with clean water and gently screw tap shaft fully into boss.
The tap will bottom out on the thread and can then be rotated,
anti-clockwise, into a vertical position. Hold the tap and secure in
position by tightening the lock nut fully; use a spanner. Secure the
bezel with the 2 screws.
3.2 Side taps fit in the same way, after removal of the blanking plug.
They are available as an accessory Part No 95 970 402 and are
supplied with suitable bezels. If the front tap is being moved to
the side a plain bezel will be required.
For safety, taps must
only be fitted when the unit is cold.
Fig.2
