Heatrae Sadia Aquatap Boil and Ambient, Installation And User Manual

Page: 8 / 36

4.0
INSTALLATION – MOUNTING THE WATER HEATING UNIT
4.1 The Aquatap water heating unit is free standing and must be positioned on a level
surface. If being mounted in a cupboard, shelf unit or false base, ensure that the
supporting surface can carry the full weight of the unit (see TECHNICAL
SPECIFICATIONS section 2.0, page 4)
4.2 Refer to fig. 1, page 4 for dimension details of the Aquatap water heating unit and the
relative positions of the water and electrical connections.
4.3 The Aquatap heater unit must be located beneath the dispensing tap.
It must be possible to connect the flexible hoses and electrical connection cable from the
dispensing tap to the OUTLET and VENT connections on the Aquatap unit. The pipes
must not be lengthened. The dispenser tap can be positioned so it discharges into a sink
or mounted on its own purposed designed drip tray (available as an accessory, product
code 95970138).
4.4 Sufficient room should be left around the unit to allow access for maintenance and
servicing (see fig. 1, page 4). Two of the case fixing screws are located on the top
rear edge of the unit; it must be ensured that these can be accessed in order to facilitate
removal of the front cover for maintenance and servicing. An ambient temperature
between 5ºC and 35ºC is required in the cupboard housing the Aquatap water heating
unit. Air circulation must be provided so air can flow through the cupboard (see diagram
below). If adequate air circulation is not provided this will cause calibration problems
and the Aquatap water heating unit will not function correctly.
4.5 The Aquatap water heating unit is supplied with a moulded plug fitted to a 1.2 metre
electrical supply cable. If the cable needs to be lengthened this must be completed by a
qualified electrician. Refer to section 9.0, page 14 - INSTALLATION – ELECTRICAL
REQUIREMENTS for full details of the electrical installation.
8