str. 2
I.
Introduction
Producer: HeatQ TECHNOLOGY Sp. z o.o. / PL /
After reading the manual, please save it just in case of need in the future
II.
Safety requirements
–
installation and use
1.
Install the electric heating element in accordance with the
producer’s guidance.
2.
Fitting and connection of the heating element should only be performed by a qualified installer.
3.
Fitting and installation of the device must be carried out in accordance with all local regulations for electrical
safety, including installation within permissible locations only. Observe bathroom electrical zone regulations.
4.
The producer does not accept any responsibility for damage or harm caused by unauthorised modification of
the electric heating element.
5.
If a suppling cable becomes damaged it shall be replaced by producer or qualified service specialist.
6.
Switching the heating element on in the open air is permitted no longer than 2 seconds.
7.
Switching the heating element on in the empty radiator is prohibited.
8.
Do NOT place the controller in contact with water or any other liquids.
9.
Each type of electric installation to which the device is connected should be done in accordance with the EU
regulations.
10.
The electric installation to which the heater is connected should have the right current differentiation and
overcurrent relay (R.C.D.) of 30 mA.
11.
Do not use any adapters or extension for operate the device.
12.
If the device is not equipped with the measure allows to disconnecting the device on all poles or plug on the
suppling cable there is oblige to install the power switch on the electric installation in accordance with the EU
requirements.
13.
Ensure that minors aged 8 and under or those with a physical or mental disability are supervised if operating
the device. Keep the device out of the reach of children.
14.
The device must be disconnected from the mains during cleaning and maintenance.
15.
Cleaning of the equipment by children under 8 years of age is only permitted under appropriate supervision.
III.
Installation of the electric heating element
(figures, page 3, 4)
CAUTION! Before installing make sure the electric heating element is not connected to the power source.
The device must not be switched when it is dry due to the risk of burning or damage of the thermal
protection.
CAUTION! Make sure the radiator is filled with water or other heating agent before switching on the
electric heating element for the first time!
a.
The electric heating element should be connected to the radiator through the bottom outlet or through a
previously assembled T-connector as shown in fig. 2.
CAUTION! The electric heating element must not be held by the cover while assembling/ disassembling.
b.
Tighten up the electric heating element with a 22-mm wrench appropriately in order to achieve required
airtightness.
c.
Rotate the electric heating element cover to the proper direction to set the front of the controller in a desired
position
–
it can be rotated by 330°. The rotation range is limited by a
palpable stopper
–
if it is not possible to
rotate the controller in one direction, try rotating in the opposite one.
d.
Fill the radiator in with the heating agent up to the required level specified by the manufacturer.
Please read this installation and user manual and warranty terms before assembling
the electric heating element.
Summary of Contents for NEX 1.0
Page 1: ...User Manual NEX 1 0 Electric heating element EN...
Page 4: ...str 4...
